|
|
|
|
|
Gate Openers Direct
8713 Katy Freeway
Houston, TX 77024
Tel: (713) 330-3333
Toll-free: (877) 688-4283
HOURS:
Mon-Fri 9am-6pm
Sat 9am-2pm
Sun Closed
Click for map
|
|
|
|
|
|
|
|
|
|
|
Home >
Telephone Entry Systems
> Linear AP-5 |
| |
|

|
|
Linear AP-5 Single
Portal Access Controller
|
|
AP-5 |
Our Price: $ 125.00 |
 |
|

The AP-5 Multipurpose Wireless Access
Controller is designed for a broad range
of applications and can control one or
two door strikes, mag-locks, barrier
gates, automatic gates, or door
operators. Its wireless design and small
size fits a variety of access control
requirements.
The unit's built-in high-gain
superheterodyne receiver picks up
transmitter signals from up to 500 feet
away. The optional EXA-2000 antenna can
be used for additional range. Up to 480
Linear MegaCode® transmitters and six
Model MGT supervised safety edge
transmitters can be programmed into the
AP-5’s memory. Up to 238 entry codes can
be programmed for activation by one or
more MegaCode® wireless keypads. The
AP-5 will retain its memory, even
without power.
Three dry contact relay outputs are
provided. One relay is dedicated for
access control, another dedicated for
obstacle detection, and the third
programmable for either access or
obstacle. Access relays can be set for
timed or latch-on/latch-off toggle
operation. The on or off toggle state of
a relay is maintained even after power
interruption. For entrapment detection,
obstacle relays activate from MGT safety
edge transmitters and connect to the
obstacle input of the access device.
OPEN REQUEST input terminals are
supplied for hardwired activation of the
access devices with an external
pushbutton or keyswitch.
The AP-5 monitors each MGT safety edge
transmitter for hourly status reports,
tamper signals, and low battery signals.
A beep will sound every 5 seconds if a
fault occurs and the trouble source can
be displayed. An access transmitter must
be activated twice to trigger the access
relay if a supervisory trouble condition
exists on any MGT transmitter.
The AP-5 can be powered from 12-24 Volts
AC or DC. The Form C relay outputs can
switch up to 1 Amp each. An EARTH GROUND
terminal is provided as a recommended
connection for maximum lightning and
static protection.
Features
- Ideal for gated communities,
parking facilities, and industrial
sites
- Easy to set-up and use, up to
480 remotes can be programmed with a
few keystrokes
- Easy to add, suspend, and delete
transmitters through programming
mode, no transmitter dip switches to
set
- Supports 480 block coded
transmitters or 238 individual
transmitters/wireless keypad entry
codes
- Supports six fully supervised
MGT safety edge transmitters
- Three output relays; one for
access, one for obstacle, one
programmable for access or obstacle
- High-gain superheterodyne
receiver
- RF frequency: 318 MHz
- 4.45" W x 5.75" H x 1.5" D
(without antenna)
These models are
ACCESSORIES for the AP-4
|
MDKP |
Exterior Wireless Keypad |
|
EXA-2000 |
Directional Remote Antenna |
|
EXA-1000 |
Omni-directional Remote
Antenna |
|
|
|
|
|
Back
to top of page |
|
|
|
|
|
|
|
|
|
|