The Doorking 9220 Series operators are designed to operate vehicular sliding gates weighing up to 2000 Lbs. These operators have a variable speed drive with slow-start / slow-stop circuitry. The mounting pedestal is optional. The heavy-duty mounting pedestal is recommended for gates weighing over 1500 Lbs. and a chain support tray is recommended for gates exceeding 20 feet in length. If a chain support tray is used, the mounting pedestal is required.
|Features||Direct driven limit nuts. |
Gate tracker reporting output.
Ports for plug-in loop detectors.
Two convenience outlets.
Fail-secure operation includes crank for manual operation.
Built-in reset switch.
Built-in power On/Off switch.
|Specifications||Maximum gate length 100-feet. |
Maximum gate weight 2000 Lb., #60 chain*. (*Assumes gate is on level ground, in good condition with properly adjusted hardware. Other external factors may affect the performance of the gate operator.)
Adjustable solid state speed control, 1/2 to 2 Ft./sec.
Slow start / slow stop function.
40:1 gear reduction running in a continuous oil bath.
2 HP continuous-duty motor.
208, 230 VAC single or three-phase.
Operator is shipped with chain brackets and 20-feet of #60 chain.
Class III and IV applications only.
ETL Listed. (Note: To be compliant with UL 325 and industry safety guidelines, a secondary entrapment prevention device(s) is required to be installed with this gate operator. Your professional DKS system installer can provide you with more details on these devices and on current industry safety standards.)
Dimensions: 20 "W x 35.5"H x 18"D
OPTIONS AVAILABLE WITH THESE OPERATORS:
#60 chain (9210, 9220 only)
Heavy-duty pedestal mounting stand. (Recommended for gates over 30-feet to allow use of a chain support rail).
Stop - Go traffic signal.
Plug-in loop detectors.
Heater kit for cold environments.