The DKS 9550 slide gate openers are designed to operate very large vehicular sliding gates up to 15,000 lbs and include an idustrial strength heavy-duty reduction system. These operators have a variable speed drive with slow-start / slow stop circuitry.
|Features||Speed control module. |
Slow start / slow stop.
Direct driven limit nuts.
Gate tracker reporting output.
Ports for plug-in loop detectors.
Two convenience outlets.
Fail-secure operation includes crank for manual operation.
Built-in reset switch.
Built-in power On/Off
|Specifications||Maximum gate length 160-feet. |
HP, maximum gate weight*, speed and chain size:
9530 - 3 HP, 10,000 Lbs., 2 ft/sec, #80 chain.
9550 - 5 HP, 20,000 Lbs., 1 ft/sec, #100 chain.
9555 - 5 HP, 10,000 Lbs., 4 ft/sec, #80 chain.
9575 - 7.5 HP, 25,000 Lbs., 2 ft/sec, #100 chain.
(*Assumes gate is on level ground, in good condition with properly adjusted hardware. Other external factors may affect the performance of the gate operator.)
Adjustable gate speed: 1/2 - 4 Ft./sec.
10:1 gear reduction running in a continuous oil bath.
Self adjusting disc brake with manual release.
5 HP continuous-duty motor.
208, 230 VAC three-phase only.
Operator is shipped with chain brackets and 20-feet of #60 chain.
Class III and IV applications only.
Compliant with UL 325 and 991 - but not yet listed. (Note: To be compliant with UL 325 and industry safety guidelines, a secondary entrapment prevention device(s) is required to be installed with this gate operator. Your professional DKS system installer can provide you with more details on these devices and on current industry safety standards.)
Dimensions: 54"W x 59"H x 26"D
OPTIONS AVAILABLE WITH THIS OPERATOR
Plug-in loop detectors.
Gate Tracker reporting (DKS 1833, 1835, 1837 or 1838 access controllers only).
Chain tray (recommended on gates exceeding 20-ft in length).
Non-contact and/or contact sensing devices.
Stop - Go traffic signal.
Heater kit for cold environments.