The FAAC Model 390 was designed to accommodate large pillar/column installations. This unit provides a sleek solution to avoid using a bulky ground unit. It reaches around the column to move the gate, allowing you to avoid the need to cut/notch out the rock or brick to accommodate a traditional residential linear actuator. These electromechanical swing gate openers are designed for light-duty, single-family residential properties. They are perfect for single swing or double swing column mount gates, wall mount gates, or carriage doors.
Our Kit INCLUDES:
Both 390 Motors, FAAC radio receiver, 2 Four Button Remotes, Photocell, Junction Box and Cable for both arms
- The system has nonreversing motors that hold the gate in the open and closed positions
- Electronic control unit with an anti-crushing device and virtual encoder with reverse function upon detection of an obstacle
- Emergency battery to ensure operation in case of power failure
- IMPORTANT to ensure correct operation, make sure that the distance between the gate hinge and the gate pier edge is a maximum of 11.8 inches (300mm)
The Electro-mechanical operator is simple to install, requiring no welding.
|Features||Features Two year limited warranty New and improved EO24U Control Board Increased gate length & weight capacity Built-in Battery Backup includes Batteries Sleek design No gate modifications are necessary Easy installation Reverse on contact Slow down "soft stop"|
|Specifications||Quick Specs Max Gate Length 14 ft Max Gate Weight 600 lbs Traveling Speed 13 - 16 Seconds per 90° Maximum Gate Swing 120 degrees Duty Cycle 100% Continuous Duty Input Voltage 115V AC Single Phase Secondary/Accessory Voltage 24V DC Operating Temperature -4°F 10 131°F Battery Backup 30-50 Cycles (average) Control Box Nema 4 (rust proof) Warranty 2 years|